So I am looking at the top cap as I am sitting relaxing and eating a lollipop wondering how to stop the auto adjusting pin... As I go to put the lollipop stick into my trash can I realize it is plastic non conductive firm but just a little bit of give... Perfect for something to screw into to hold tension like a bushing...
Step 1 complete, I have found a material I can use that should fit my needs... Step 2... Dry fitting...
I took the end that was not in my mouth and put in the hole... I wanted it not too loose so I wouldnt accidentally crank down on it and smash it... At the same time it had to fit in the hole. The next step is modifying to meet your needs.
This part takes some trial and error... I cut with flush cutters 3 times before I got the right length that is why it was important that it was not to tight so I could take it out if need be. Next step is to fit and test.
As you can see there is space in between the 2 screws how ever it has stopped backing out or screwing in on me thanks to my plastic bushing made out of something I was going to throw away... Next up making the switch not stick...
